Product Specifications for C175-16 (60 Hz)

C175-16 (60 Hz) Standard Equipment

Air Inlet System

• 4 x Single element canister with service indicator(s).

Control Panel

• 2 Programmable relay outputs (Form C)

• Low coolant level

• Over/under voltage

• Coolant temperature

• Serial annunciator module data link

• Alarm acknowledge

• Text alarm/event descriptions

• Volts (L-L & L-N)

• Reverse power

• Over/under frequency

• Environmental sealed front face

• Programmable protective relaying functions

• Speed adjust

• Generator phase sequence

• Low coolant temperature

• Generator mounted - rear facing

• Overspeed

• Controls

• Frequency (Hz)

• Engine cycle crank

• Engine cool-down timer

• Warning/shutdown Indicators:

• Lamp test

• 2 Programmable digital outputs

• 6 Programmable digital inputs

• High coolant temperature

• Customer data link (Modbus RTU)

• Auto/start/stop control

• Emergency stop pushbutton

• RPM

• Digital Indicators

• Communications

• Accessory module data link

• Oil pressure (psi, kPa or bar)

• Low oil pressure

• Overcurrent

• Emergency stop

• 24 Volt DC operation

• 4 Programmable relay outputs (Form A)

• Failure to start (overcrank)

• True RMS AC metering, 3-phase, +/-2% accuracy

• Power factor (per phase & average)

• Operating hours

• DC volts

• Amps (per phase & average)

• Cat ECS 100

• Reverse reactive power

Exhaust System

• Bolted flange, with bellow for each turbo

• Exhaust flange outlet

Fuel System

• Engine mounted filters #REF!

• Filters x 3

• 10 Micron spin on yype

• Secondary/tertiary fuel filters

• 4 Micron spin on type

• Primary fuel filter water/fuel water separator

Generators and Attachments

• Right side extension box, bottom cable entry

• IEC platinum stator RTDs

• Reactive droop capability

• 3 Phase voltage sensing

• (MV) Busbar connections, right side extension box, bottom cable entry

• Class F temperature rise at 40C ambient

• Anti-condensation space heater

• NEMA Class H insulation

• 6 Leads

• Class H temperature rise at 40C ambient

• Voltage regulator

• Exciter diode monitor

• Form wound

• RFI suppression

• (LV) Busbar connections, top/center mounted, top cable entry

• 3 Phase brushless

• 60 Hz models: NEMA standard hole pattern

• Permanent magnet excitation (PMG)

• Min / max exciter limiter

• Salient pole

Governing System

• Redundant shutdown (Overspeed protection through a duplicate speed sensing system)

• ADEM A4

Lube System

• Oil filter, filler and dipstick

• Integral lube Oil cooler

• Oil drain lines and valve

• Fumes disposal

• Lubricating oil

• Prelube - required with prime, continuous, and standby

• Gear type lube oil pump

Mounting Systems

• Rails - Engine/generator

• Rubber anti-vibration mounts - shipped loose

• Dual 24 volt electric starting motors

• Battery disconnect switch

• Batteries and battery rack w/cables

Power Termination

• Busbar

Service Instructions

• Two PM inspections

General

• Paint - Caterpillar yellow with high gloss black rails & radiator

• SAE standard rotation

• LH Service

• Flywheel and flywheel housing-SAE No. 00

C175-16 (60 Hz) Optional Equipment

Air Inlet System

• Air inlet adapters

• Dual element air cleaner

• Single element air cleaner

• Air inlet protection

Control Panel

• Package mounted radiator

• Automatically selected ground

• Customer AC-DC connection mounting location - LV/MV

• Load share governor

• EMCP 4.4

• E-Stop

• Frame boxes

• Annunciator modules

• Load share module / auxiliary plate and auxiliary box (LV)

• Fuel cooler

• Controller mounting location - LV/MV

• Modbus monitoring of packages

• Customer interface options

• EMCP 4.4 optional harness

• Controller voltage and current sensing groups

• Remote radiators

• Generator harness

• Interconnect harness

• Speed adjust

• Controller and MV and HV power connection locations

• Raise lower switch

Crankcase Systems

• Explosive relief valves

• Crankcase ventilation system

Exhaust System

• Mufflers

• Exhaust support group

• Weld flanges

• Exhaust collectors/manifold

• Front housing - Prime or continuous

• Front housing - Standby or mission critical

• Aftercooler drain

Fuel System

• Primary fuel filter

Generators and Attachments

• Low voltage - 1800 and 3000 Frames - 60 Hz, 3 phase, 1800 rpm, FW, PM, No of leads=6, Pitch 0.6667

• Medium voltage - 1800 and 3000 Frames - 60 Hz, 3 phase, 1800 rpm, FW, PM, No of leads=6, Pitch 0.6667

• Conversion GP - Top cable entry

• Low voltage - 1800 and 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667

• Differential current transformers

• Space heater kit

• Medium voltage - 1800 and 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667

• Thermostat for space heater

• Generator air intake

Instrumentation

• Pyrometer and thermocouples

Lube System

• Drain group oil pans

• Oil filters

• Lube oil heater

• Electric prelube pumps

• Lubricating oil

Mounting Systems

• IBC vibration isolators - Shipped loose

• Spring type linear vibration isolators

• Rubber anti-vibration mounts

Power Connections

• Low voltage connection cable

• Center post busbarss (LV)

• 1800 Frame generator side / rear mounted busbars (MV)

• Enclosures - Control packaging (LV)

• Paralleling circuit breakers

• 1800 Frame generators Circuit breaker

• Neutral ground (LV)

• Neutral ground (MV)

• Cable entry options (LV)

• Cable entry options (MV)

• Masterpack breakers

• Power connection covers (LV)

• Harnesses (Breaker)

• Masterpack breaker connections

• Side/rear mounted busbars (LV)

Special Tests / Reports

• IBC seismic Certification

• Special test charge - Engine only

• PGS Test report @ 0.8 power factor

• Genset fuel consumption test

• Standard genset TVA (Torsional Vibration Analysis) report

• PGS Test report @ 1.0 power factor

• OSCOSH1 seismic Certification

• Custom generator TVA report

• Generator test report

• Standard engine test charge

Starting / Charging System

• Heavy duty battery sets with rack

• Charging alternators - Dry

• Air pressure regulator

• Starter location covers

• 24 Volt power distribution box

• 24 Volt electric starting motor

• 35 Amp Battery chargers

• 24 Volt battery set - Dry

• 20 Amp Battery chargers

• Jacket water heaters

• 50 Amp Battery chargers

• Air starting motor

• Jacket water heater wiring groups

General

• Special paint colors

• Control GP - air powered bar group

• Barring group manual

• Service tools - Engine barring group

• Engine barring air powered