Diesel Generator Sets C175-16 (50 Hz)

C175-16 (50 Hz) Standard Equipment

Air Inlet System

• 4 x Single element canister with service indicator(s)

Control Panel

• EMCP 4.2B

• Volts (L-L & L-N)

• Engine cycle crank

• Power Factor (per phase & average)

• Overcurrent

• Communications

• Emergency stop

• 2 Programmable relay outputs (Form C)

• 6 Programmable digital inputs

• 2 Programmable digital outputs

• Environmental sealed front face.

• DC Volts

• Reverse power

• Programmable Protective Relaying Functions

• High coolant temperature

• Accessory module data link

• Low coolant level

• Over / under frequency

• Amps (per phase & average)

• True RMS AC metering, 3-phase, +/-2% accuracy

• Low coolant temperature

• Reverse Reactive Power

• Controls

• Oil pressure (psi, kPa or bar)

• Lamp test

• Coolant temperature

• Warning / shutdown Indicators

• 4 Programmable relay outputs (Form A)

• Alarm acknowledge

• Generator phase sequence

• 24 Volt DC operation

• Serial annunciator module data link

• Customer data link (Modbus RTU)

• Failure to start (overcrank)

• Auto / start / stop control.

• Low oil pressure

• RPM

• Text alarm / event descriptions.

• Digital Indicators

• Generator mounted - rear facing

• Emergency stop pushbutton

• Engine cool-down timer.

• Operating hours

• Over / under voltage

• Overspeed

• Frequency (Hz)

Cooling System

• Radiator group - shipped loose

• SCAC cooling

• Coolant Sensors

• Coolant drain line and valves

• Fan and belt guards

Exhaust System

• Bolted flange, with bellow for each turbo

• Dry Exhaust Manifold

Fuel System

• Filters x 3

• Secondary / Tertiary fuel filters

• 10 Micron Spin On Type

• 4 Micron Spin On Type

• Primary fuel filter water / fuel water separator

• Engine mounted filters X3

Generator and Attachments

• 6 Leads

• IEC platinum stator RTDs

• Voltage regulator

• Reactive droop capability

• 3 Phase voltage sensing

• RFI suppression

• Min / max exciter limiter

• exciter diode monitor

• Form Wound

• Permanent magnet

• NEMA Class H insulation

• Class H temperature rise at 40C ambient

• (LV) Busbar connections, top/center mounted, top cable entry

• 3 Phase Brushless

• Salient pole

• 50 Hz models: IEC standard hole pattern

• (MV) Busbar connections, right side extension box, bottom cable entry

• Anti condensation space heater

• Class F temperature rise at 40C ambient

• Right side extension box, bottom cable entry

Governing System

• ADEM A4

• Redundant shutdown (Overspeed protection through a duplicate speed sensing system)

Lube System

• Gear type lube oil pump

• Lubricating oil

• Fumes disposal

• Integral lube oil cooler

• Oil drain lines and valve

• Oil filter, filler and dipstick

• Prelube - required with prime, continuous, and standby

Mounting Systems

• Rubber anti-vibration mounts (shipped loose)

• Battery disconnect switch

• Batteries and battery rack w/cables

• Dual 24 volt electric starting motors

• Rails - Engine / generator

Service Instructions

• Two PM inspections

Power Termination

• Busbar

General

• Paint - Caterpillar yellow with high gloss black rails & radiator

• Right hand service

• Flywheel and flywheel housing-SAE No. 00

• SAE standard rotation

C175-16 (50 Hz) Optional Equipment

Air Inlet System

• Single element air cleaner

• Dual element air cleaner

• Air inlet adapters

• Air inlet protection

Control Panel

• EMCP 4.3, EMCP 4.4

• EMCP 4.4 optional harness

• EMCP and MV&HV power connection locations

• Load share module

• EMCP mounting location - LV / MV

• Customer AC-DC connection mounting location - LV/MV

• Load share module / auxiliary plate and auxiliary box (LV)

• Load share governor

• Frame boxes

• Automatically selected ground

• EMCP voltage and current sensing groups

• Raise lower switch

• Speed adjust

• Annunciator modules

• Customer interface options

• Generator temperature monitoring

• Modbus monitoring of packages

• E-Stop

• Interconnect harness

• Generator Harness

Cooling System

• Package mounted radiator

• Remote radiators

• Fuel cooler

Exhaust System

• Front housing - Standby or mission critical

• Front housing - Prime or continuous

• Exhaust collectors / Manifold

• Exhaust support group

• Mufflers

• Weld flanges

• Aftercooler drain

Crankcase Systems

• Explosive relief valves

• Crankcase ventilation system

Fuel System

• Primary fuel filter

Generators and Attachments

• Low voltage - 1800 and 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667

• Medium Voltage - 1800 and 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667

• Low Voltage - 1800 and 3000 Frames - 60 Hz, 3 phase, 1800 rpm, FW, PM, No of leads=6, Pitch 0.6667

• Space heater kit

• Thermostat for space heater

• Conversion GP-Top cable entry

• Generator air intake

• Differential current transformers

Instrumentation

• Pyrometer and thermocouples

Lube System

• Lube oil heater

• Drain group oil pans

• Lubricating oil

• Electric prelube pumps

• Oil filters

Mounting

• Rubber anti-vibration mounts

• Spring type linear vibration isolators

• IBC vibration isolators - Shipped loose

Power Connections

• Center post busbars (LV)

• Side / Rear mounted busbars (LV)

• Harnesses (Breaker)

• Cable entry options (LV)

• Enclosures - Control packaging (LV)

• Power connection covers (LV)

• Neutral ground (LV)

• 1800 Frame generators circuit breaker

• Masterpack breakers

• Paralleling circuit breakers

• 1800 Frame generator side / rear mounted busbars (MV)

• Cable entry options (MV)

• Neutral ground (MV)

• Low voltage connection cable

• Masterpack breaker connections

Special Tests / Reports

• Generator test report

• PGS test report @ 1.0 power factor

• PGS test report @ 0.8 power factor

• Standard genset TVA (Torsional Vibration Analysis) report

• Custom genset TVA report

• Special test charge - Engine only

• Genset fuel consumption test

• Standard engine test charge

• IBC seismic certification

• OSCOSH1 seismic certification

Starting / Charging System

• 24 Volt power distribution box

• 24 Volt electric starting motors

• Air starting motor

• Air pressure regulator

• Starter location covers

• 24 Volt battery sets - Dry

• Heavy duty battery sets with rack

• 20 Amp battery chargers

• 35 Amp battery chargers

• 50 Amp battery chargers

• Charging alternators - Dry

• Jacket water heaters

• Jacket water heater wiring groups

General

• Special paint colors

• Service tools - Engine barring group

• Barring group manual

• Engine barring air powered

• Control GP - Air powered bar group