Product Specifications for C175-20 (60 Hz)

C175-20 (60 Hz) Standard Equipment

Air Inlet System

• 4 x Single element air cleaner canisters with service indicator(s).

Control Panel

• 24 Volt DC operation

• 4 Programmable relay Inputs

• 4 Programmable relay output

• Alarm acknowledge

• Amps (per phase & average)

• Auto/start/stop control

• Coolant temperature

• DC volts

• Digital indicators

• Cat ECS 100

• Emergency stop

• Emergency stop pushbutton

• Engine cool-down timer

• Engine cycle crank

• Environmental sealed front face

• Failure to start (overcrank)

• Frequency (Hz)

• High Coolant temperature

• Lamp test

• Low coolant level

• Low oil pressure

• Oil pressure (psi, kPa or bar)

• Operating hours

• Overspeed

• RPM

• Speed adjust

• Text alarm/event descriptions.

• True RMS AC metering, 3-phase, +/-2% accuracy

• Volts (L-L & L-N)

• Wall mounted controls:

• Warning/shutdown Indicators:

Cooling System

• AC Inlet: 6" ANSI / AC Outlet: 3-1/2" ANSI

• Coolant sensors

• JW Inlet: 6" ANSI / JW Outlet: 5" Cat Flange

• SCAC cooling

Exhaust System

• Dry exhaust manifold

• Dual ANSI 18" / DIN 450 flanges. Shipped loose. Support required from installation

Fuel System

• 10 Micron spin on yype

• 4 Micron spin on type

• Engine mounted filters x 3

• Filters x 3

• Primary fuel filter water/fuel water separator

• Secondary/tertiary fuel filters

Generators and attachments

• 3 Phase brushless

• 3 Phase voltage sensing

• 6 Leads

• Anti-condensation space heater

• Class H temperature rise at 40C ambient

• Exciter diode monitor

• Form wound

• IEC platinum stator RTDs

• Min / max exciter limiter

• NEMA Class H insulation

• Permanent magnet excitation (PMG)

• Reactive droop capability

• RFI suppression

• Right side extension box, bottom cable entry

• Salient pole

• Voltage regulator

Governing System

• ADEM A4

• Redundant shutdown (Overspeed protection through a duplicate speed sensing system)

Lube System

• Fumes disposal

• Gear type lube oil pump

• Integral lube Oil cooler

• Lubricating oil

• Oil drain lines and valve

• Oil filter, filler and dipstick

Mounting Systems

• Rails - Engine/generator

• Rubber anti-vibration mounts - shipped loose

Starting / Charging System

• Batteries and battery rack w/cables

• Battery disconnect switch

• Dual 24 volt electric starting motors

General

• Paint - Caterpillar yellow with high gloss black rails

• Right hand servicing

• SAE standard rotation

C175-20 (60 Hz) Optional Equipment

Air Inlet Systems

• Single element air cleaner

Control Panel

• EMCP 4.4

• Controller and MV and HV power connection locations

• Controller voltage and current sensing groups

• E-Stop

• Generator harness

• Generator temperature monitoring

• Interconnect harness

• Load share module

• Modbus monitoring of packages

• Speed adjust

• Vandal proof panel door

• Annunciator modules

• Customer interface options

Cooling System

• Fuel cooler

• Package mounted radiators

• Remote radiators

Crankcase Systems

• Crankcase ventilation system

• Explosive relief valves

Exhaust System

• Exhaust collectors/manifold

• Front housing - Prime or continuous

• Front housing - Standby or mission critical

• Mufflers (15, 25 and 34 dBA silencers)

Fuel System

• Primary fuel filter

Generator

• Anti-condensation heater

• Internal excitation (IE)

• Oversize and premium generators

• Permanent magnet excitation (PMG)

Generators and Attachments

• Differential current transformers

• Generator air cleaner

• Medium voltage - 3000 Frames - 60 Hz, 3 phase, 1800 rpm, FW, PM, No of leads=6, Pitch 0.6667

• Thermostat for space heater

Instrumentation

• Pyrometer and thermocouples

Lube System

• Drain group oil pans

• Electric prelube pumps

• Lube oil heater

• Lubricating oil

• Oil filters

Mounting System

• IBC vibration isolators - Shipped loose

• Rubber anti-vibration mounts

• Spring type linear vibration isolators

Power Termination

• Circuit breakers, IEC compliant

• Circuit breakers, UL listed

Special Tests / Reports

• Custom generator TVA report

• Generator test report

• Genset fuel consumption test

• PGS Test report @ 0.8 power factor

• PGS Test report @ 1.0 power factor

• Special test charge - Engine only

• Standard engine test charge

• Standard genset TVA (Torsional Vibration Analysis) report

Starting / Charging System

• 20 Amp Battery chargers

• 24 Volt battery set - Dry

• 24 Volt electric starting motor

• 35 Amp Battery chargers

• 50 Amp Battery chargers

• Air pressure regulator

• Air starting motor

• Charging alternators - Dry

• Jacket water heaters

• Starter location covers

General

• Barring groups:

• Control GP - air powered bar group

• Engine air powered

• Engine barring group

• Manual

• Special paint - 3500